The picture above that I made on 16 April indicated two exactly same function programs with two kinds of programming software. The left one is Bricx CC and the right one is LabVIEW. This is a follow line program. The logical translation of this program is determined the value of light sensor, if both are greater than 80, go straight, if left light sensor is below 48 then turn left, if right light sensor is below 48 then turn right.
I spend 2 minutes to type the language up, but dragging the icons cost me 7 minutes. That is why I believe that traditional programming is better than graphic programming. It is faster, more accuracy and more logical. From the research and compression, I believe that there is enough proof to prove this point. Programming is an important of robotics, therefore choosing good programming software is no doubt important, and I suggest everyone, which is on advanced level to use traditional language programming software instead of graphic programming software.
I spend 2 minutes to type the language up, but dragging the icons cost me 7 minutes. That is why I believe that traditional programming is better than graphic programming. It is faster, more accuracy and more logical. From the research and compression, I believe that there is enough proof to prove this point. Programming is an important of robotics, therefore choosing good programming software is no doubt important, and I suggest everyone, which is on advanced level to use traditional language programming software instead of graphic programming software.